OP Rootstocks?

Started by Tim DH, 2021-11-22, 10:31:26 AM

Previous topic - Next topic

William Schlegel

#30
Neat, sounds like from reading the article like this rootstock is also becoming edible in its own right. That makes it a parallel story to the other high percentage Solanum habrochaites breeding efforts we know about. Joseph Lofthouse's and Lee Goodwin's. Eventually you can get back a palatable tomato.
Western Montana garden, glacial lake Missoula sediment lacustrian parent material and shallow 7" silty clay loam mollisoil topsoil sometimes with added sand in places. Zone 6A with 100 to 130 frost free days

Tim DH

#31
Hi There,
   Here is an interesting little thing. All the tomato grafting advice I've read talks about setting up a Healing Chamber, where you manipulate the light and humidity during the healing process.

   After selecting my Potato Leaf F2s (See Thread Back Crossing Latah) I had a whole load of scrap seedlings. So I thought I'd use them to trial sort of 'bud only' grafting!

   I cut the rootstock just above the cotyledons and attached a leafless section of stem on top. These grafts got no special treatment regarding light or humidity.

   At least some of them have taken!

   My next step with is one (were I interested in growing it on) would be, in a couple of days time, to remove the shoots developing from the cotyledon axils.

   SO If you've ever been put off doing a bit of grafting by the hassle of setting up and operating a Healing Chamber, its not actually necessary!!! Just don't graft scions with leaves on.

        I guess it will take a bit longer for these grafts to catch up, but that's easily accounted for by starting a bit earlier. My Healing Chamber has limited space, so I might use this trick if/when I want to ramp up production.



Tim DH

Tim DH

As mentioned further back, I suspect the viability of commercial F1 seed, in the years after its intended season of use.

Here I planted 11 seed intended for the 2022 Season (pots labelled green) and 21 seed intended for the 2021 season (pots labelled red)

The 2021 seed is a complete no show

The 2022 seed has six out of 11 coming up, tho only two of them look properly healthy. My experience from last year suggests that the poor seedlings will recover given time, however in a normal grafting operation timing and uniformity are critical.

It proves, to my satisfaction at least, that I can't buy a decent sized packet of (expensive) commercial F1s and expect it to last me three or four years.

When I (finally) get a bit more growing space I'll definitely devote a bit of it to working on the OP Rootstocks. I'm confident that the seed I have so far raised will be good for YEARS!

Roland

Dit u try to store seeds at -18C?
Netherlands

Tim DH

Hi Roland,
    I store my seed at 'room' temperature in an unheated garage. The garage roof has four tonnes of gravel on it, so it maintains an even temperature, slowly rising and falling with the seasons.

Tim DH

Tim DH

   I did my first grafting session last night. The six variable seedlings (see above) from 'stale' primed seed planted on Feb 2nd, had yielded 14 stumps. The 21 'fresh' primed seeds planted March 7th had all germinated.

   SO I can now make a comparison between grafting onto fresh stumps and grafting onto 'held' (or 'stored') stumps.

   I was using 18 different scions and made 35 grafts. 14 of the grafts are pairs (same scion on fresh and held stumps)

   My first impression is that the stored stumps are easier to work with because they are slightly stiffer.

   Even tho' these are all F1 rootstocks, knowing how 'held' stumps perform will make taking the OP Rootstock project forward much easier.

Tim DH

Tim DH

The first Grafting Session produced 32 plants out of 33 attempts. There appears to be no significant difference between using 'fresh' stumps and 'held' stumps.

I do two rounds of seedlings/grafts. The earlier set for the greenhouse and a later set for outdoors. Knowing I can squeeze maybe six rootstocks out of each seed certainly makes the economics of using commercial seed more acceptable. ... So long as I can always find a supplier who deals in small numbers!

These are examples from my arsenal of grafting clips. ...

Type A: I like the length of the jaws on these (15mm), but the hole inside the jaws is more leaf shaped than round, which doesn't help when trying to join two round stems. Also the plastic is rigid, which means it isn't very forgiving when the two stems to be joined aren't exactly the same size.

Type B: Softer plastic than Type A and rounder hole in jaws, but only 11mm long.

Type C: The softest plastic and a perfectly round hole, which I reckon is 2.46mm across. Lighter than B, so less likely to bend a stem over. Only 11mm long

Type D: Very light. Nice long jaws (15mm) Good round hole, but the plastic is almost as hard as A.

My ideal clip would be a slightly smaller, (2.2mm) slightly longer (15mm) Type C.

Tim DH

   
   

Adrian

Can i use raffia for graft tomatos?

AndrewB

Is this something where I could help you design a better one using 3D printing?

I feel like I've seen another clip design on Amazon or catalogs. But maybe you have them all.

What about grafting tape?

Kadence Luneman

Just watched a video on tomato grafting. There will be follow up videos on how it goes. And as someone who had never heard of tomato grafting before this forum it was interesting to see.

https://youtu.be/5o4ZXWqh2Qk

Tim DH

Hi Adrian,
   I don't fancy trying to use raffia! If you can figure out a quick and easy way of making it work, post us some pictures.



Hi Andrew,
   Thanks for the 3D printing offer. I don't think I have any 'new' design ideas. I have found what I want, sadly they only seem to come in commercial quantities!
   I've got plenty of functional/useable clips for this season. In the Autumn if I can't find anyone selling my ideal clip in sensible quantities, I might take the plunge and place a stupidly huge 'minimum order'. Then split up the excess and put them on Ebay in more useful amounts!!
   
   I've got grafting tape, which I use for apples/pears. That is a fiddly enough job. I think downsizing the procedure for tomatoes would be a nightmare!



Hi Kadence,
   I quite enjoy doing the tomato grafting. Its a job that fits into a quiet time of year, gardening-wise. However, the real driver for doing it is the improved yield. After years of tomato growing, I had built up a formidable soil borne disease pressure. I decided that, for me, fumigating the greenhouse soil was a non-starter. So too was replacing the greenhouse soil on a regular basis. ... Grafting works. ... Whether it will always work remains to be seen. ... But I'll cross that bridge when I get to it. 

Tim DH

AndrewB

#41
What about this?

https://www.neseed.com/shop/growing-supplies/rootstock-grafting-supplies/tube-clips-for-tomato-and-eggplant-grafting/


Okay, well if you want to take design C and make it longer I might be able to help. Or you could try superglue and glue 2 together, haha

Tim DH

Hi Andrew,
      Thanks for the link. Those are exactly what I want EXCEPT:

1) They are half a dollar each.
2) They are in America, so the postage is likely to be a fair bit.
3) They are actually out of stock!!

       I'll search again in the Autumn. .......

Tim DH

Cathy A

I agree with Rolland that keeping seeds frozen is likely to extent their storage lifetime. I haven't done it myself, but  I think it's worth considering.

Even with the varieties I am trialing for Vermont Short & Sweet, I am seeing noticeably higher germination rates from the 2022 seeds than from earlier years. This is from seeds stored in mason jars indoors, in a reasonably cool but not refrigerated area, and kept covered with a towel for darker storage.

Roland

This one is sometimes used as rootstock:
Petit Moineau
Netherlands